Products  |  Theory of Machines and Properties of Materials  |  Statics  |  WP 960
WP 960 Shearing Force and Bending Moment Apparatus Show data sheet (pdf file)
Technical Description
This demonstration unit facilitates the experimental investigation of the progression of the bending moment and shearing forces on a bar subject to point loads. In addition, the section principle commonly used in mechanics can be demonstrated. Due to the use of a low friction joint with two degrees of freedom at 1/3 of the span and two dynamometers, the measurements can be recorded directly from the bar. The deflection of the bar as result of the travel of the dynamometers and the horizontal alignment can be compensated and regulated using two adjustment bolts. The bar is loaded with graduated sets of weights that can be attached at any point on the bar.
Learning Objectives / Experiments
· Determination of the progression of the bending moment and shearing force on a bar
- Loaded with one point load
- Loaded with two point loads
Features
· Demonstration of the section principle in mechanics
· Calculation of section load on the bar
Alternative products
SE 110.10 -- Experimental Set Shear Forces (Influence Lines)
SE 110.11 -- Experimental Set Bending Moment (Influence Lines)
SE 110.15 -- Experimental Set Bending Moment and Shear Force
WP 961 -- Shearing Force Apparatus
WP 962 -- Bending Moment Apparatus
Specification
[1] Table unit for demonstrating shearing forces and bending moments on bending bars
[2] Bar length 1000mm, span 800mm
[3] Joint positioned at 1/3 span
[4] Bending moment measuring range 0...140Nm
[5] Shearing force measuring range 0...50N
[6] Set of weights up to 20N point load
[7] l x w x h 1400x320x600mm
Technical Data
Total length of bar: 1000mm
Span: 800mm
Bending moment measuring range: 0...140Nm
Shearing force measuring range: 0...50N
Max. load: 20N
Dimensions and Weight
l x w x h : 1400 x 320 x 600 mm
Weight : approx. 35 kg
Scope of Delivery
1 apparatus complete,
1 set of experiment instructions
Order Details
020.96000 WP 960 Shearing Force and Bending Moment Apparatus
© 2005 G.U.N.T. Gerätebau GmbH