Products  |  Fluid Mechanics and Hydrology  |  Flow in Pipes  |  HM 125
HM 125 Pipe Friction Bench Show data sheet (pdf file)
Technical Description
The test stand for investigating losses in pipes is a complete, closed experimental set-up. Due to the installation of the set-up on a laboratory trolley and the closed water circuit with supply tank and pump, the test stand is flexible in use. Eight different pipe sections are provided for the investigations, these are equipped with annular chambers with measuring connections for pressure measurements. The pipes can be individually selected for the investigations using ball-cocks. Double tube manometers are provided for pressure measurements along with a battery-operated electronic differential pressure gauge. The flow rate is indicated on a variable-area flow meter. An instruction manual with detailed description of the theoretical background is supplied.
Learning Objectives / Experiments
· Familiarisation with pressure measurements, differential pressure measurements
· Influence of pipe diameter
· Influence of different materials and surface roughness
· Influence of flow velocity
· Pressure losses in pipe elbows and bends
· Pressure losses on changes in cross-section
· Determination of drag coefficients
· Comparison between experiment and calculation
Features
Test stand for the investigation of flow in pipes
Flexible in use due to laboratory trolley
Closed water circuit with supply tank and pump
Wide range of experiments
Alternative products
HM 110 -- Hydrodynamics Trainer
HM 120 -- Pipe Fitting Loss Demo Panel
HM 122 -- Fluid Friction in Pipes and Fittings
Specification
[1] Test stand for investigating pressure losses in pipes through which a liquid is flowing
[2] Complete, closed test stand on laboratory trolley
[3] Closed water circuit with 30Ltr supply tank and 0.22kW pump
[4] Electronic differential pressure gauge 0..2000mbar
[5] Double manometer, 680mmWC
[6] Variable-area flowmeter 1900Ltr/h
[7] 8 different pipe sections for experiments
[8] Standard measured length of 1000mm for pipe friction measurements
[9] Pressure measurement using annular chambers
Technical Data
Pipe sections
With elbows and bends 18x1mm, Cu
Straight, 18x1mm, L=1000mm, Cu
Straight, 22x1mm, L=1000mm, Cu
Straight, 28x1mm, L=1000mm, Cu
Enlarged from 15x1 to 22x1mm, Cu
Reduced from 22x1 to 15x1mm, Cu
Straight, 20x1.5mm, L=1000mm, PVC
Straight, ½", L=1000mm, galvanized steel
Pump
Max. head: 12.5m
Max. capacity: 5700Ltr/h
Dimensions and Weight
l x w x h: 1520 x 750 x 1950 mm
Weight : approx. 95 kg
Connections
230V, ~50Hz
Scope of Delivery
1 test stand, 1 set of connecting hoses, 1 instructions manual
Order Details
070.12500 HM 125 Pipe Friction Bench
© 2005 G.U.N.T. Gerätebau GmbH