This training system provides a comprehensive experimental introduction to the fundamentals of process control using an example of flow control. All components are clearly laid out on a vertical front panel. The large-format process diagram provides an aid to understanding. A pump transfers water from a storage tank into the piping system. The flow is measured by an electronic paddle-wheel flowmeter. The transparent variable-area flowmeter enables the control process to be observed very clearly. The controller used is a state-of-the-art digital industrial controller. The actuator in the control loop is an electric control valve. A ball valve in the pipe system enables defined disturbance variables to be generated. The controlled variable X and the manipulating variable Y can be tapped as analogue signals at lab jacks. This enables external recording equipment, such as a plotter or an oscilloscope, to be connected. 
An instrumentation and control software (RT 650.40) with interface module (USB) is available as an accessory. This enables the key process variables to be represented, and control functions executed.
 
The well-structured instructional material outlines the technological fundamentals and provides a step-by-step guide through the experiments.

- Introduction to the fundamentals of process control
- Familiarisation with latest industrial process control

  components: controllers, transducers, actuators
- Operation and parameter setting of a multi-

  functional state-of-the-art digital controller: e.g.

  parameter setting as P, PI and PID controller
- Investigation of disturbance and control response
- Influence of different control parameters on stability

  and control quality
- Investigation of the properties of the open and

  closed control loops

- Processing of process variables using external

  equipment, e.g. plotter or oscilloscope

- In conjunction with accessory RT 650.40:

  Familiarisation with and use of I&C software