Products  |  Theory of Machines and Properties of Materials  |  Structural Mechanics  |  SE 110  |  SE 110.10
SE 110.10 Experimental Set Shear Forces (Influence Lines) Show data sheet (pdf file)
Technical Description
The set is used an accessory for the SE 110/SE 111 universal test frames to investigate the shear forces in a beam loaded with point forces. The shear force in the beam can be measured directly. This is made possible by the combination of a special low-friction joint, not rigid in shear at 1/3 of the span, and a mechanical dynamometer. The deflection of the end of the beam at the joint as a result of the travel of the dynamometer is compensated using adjustment bolts. The beam is loaded using sets of weight that can be attached to the beam at any point. Ball bearing mounted rollers on supports are used as bearings.
Learning Objectives / Experiments
· Demonstration of the section principle in mechanics
· Calculation of section load on the beam
· Progression of the shear force along a beam on the application of point forces
Features
Special low-friction joint, not rigid in shear, fitted in the beam
Measuring travel compensation of the dynamometer
Alternative products
SE 110.15 -- Experimental Set Bending Moment and Shear Force
WP 960 -- Shearing Force and Bending Moment Apparatus
WP 961 -- Shearing Force Apparatus
Specification
[1] Supplementary experiment in the SE 110/SE 111 table-top system, shear forces (influence lines) in beams
[2] Bar length 1000mm, span 800mm
[3] Low friction joint, rigid to normal forces and moment, but not to shear forces
[4] Dynamometer ±50N
[5] Max. load 20N
[6] Ball bearing mounted bearings, width 20mm
Technical Data
Total length of beam: 1000mm
Span: 800mm
Dynamometer: ±50N
Max. load: 20N
Ball bearing mounted bearings
Dimensions and Weight
Weight : approx. 16 kg
Scope of Delivery
1 experimental set-up, complete, 1 instruction manual
Order Details
022.11010 SE 110.10 Experimental Set Shear Forces (Influence Lines)
© 2005 G.U.N.T. Gerätebau GmbH