Products  |  Theory of Machines and Properties of Materials  |  Material Testing  |  WP 300  |  WP 300.04
WP 300.04 Bending Device Show data sheet (pdf file)
Technical Description
Using this accessory for the WP 300 universal material tester, a bending bar is investigated. This is mounted on two supports and loaded with a point force generated by the tester. By sliding the bearing it is possible to apply the force in different positions and change the support width. An I-section steel beam is used as the base. This is straightforwardly bolted to the lower cross-member on the WP 300. Using the apparatus, the relationship between load and elastic deformation can be demonstrated. The influence of the modulus of elasticity and planar moment of inertia is also demonstrated.
Learning Objectives / Experiments
· Loading of a bending bar by a point force
· Influence of modulus of elasticity and planar moment of inertia on elastic deformation
Features
· Elastic deformation of a bending bar by a point force
· Support width and point of application of force can be chosen
Specification
[1] Supplementary experiment on the WP 300 universal material tester for the elastic deformation of bending bars subject to a point force
[2] Test bar made of cold drawn flat steel
[3] Cross-section 40x12mm, length 320mm
[4] Support width adjustable 100...300mm
[5] Moveable bearing, semicircular seat
[6] I-section steel beam as bearing base
[7] Comprehensive experiment instructions, also as pdf
Technical Data
Bending bar: flat steel cold drawn
Bar cross-section: 40x12mm
Bar length: 320mm
Support width, adjustable: 100...300mm
Scope of Delivery
1 bending device,
1 set of experiment instructions
Order Details
020.30004 WP 300.04 Bending Device
© 2005 G.U.N.T. Gerätebau GmbH