G.U.N.T. - Equipment for engineering education

Products | Theory of Machines and Properties of Materials | Strength of Materials | WP 130 | WP 130.01

WP 130.01

Set of 4 Specimens Alum., Copper, Steel Brass, 1 each

Technical Description

This set of material specimens is available as an accessory for the WP 130 tester. The specimens have a ring-shaped cross-section in the area loaded. The ends of the specimens are appropriately reinforced for clamping to the WP 130. The set contains one specimen made of aluminium (AlMgSi0,5F22), one of copper (E-Cu), one of brass (CuZn39Pb3) and one of steel (St37).

Learning Objectives / Experiments

Multiple axis loading of specimens by combined torsion and bending of the WP 130 tester
· Determination of the yield point
· Checking the direct stress hypothesis
· Checking the shear stress hypothesis

Features

Specimens made of different materials for bending and torsion loading on the WP 130 tester

Specification

[1] Accessory set of specimens made of different materials for experiments on multiple axis stress states on the WP 130 tester
[2] Test length 24mm, total test length 49mm
[3] Specimen diameter, outside 4mm, inside 3mm
[4] Rod material: aluminium, copper, steel, brass

Technical Data

Rod diameter:
Outside Ø4mm, inside Ø3mm
Test length: 24mm
Total rod length: 49mm

Scope of Delivery

1 aluminium specimen, 1 copper specimen
1 steel specimen, 1 brass specimen,

Order Details

020.13001 WP 130.01 Set of 4 Specimens Alu., Copper, Steel, Brass