Products  |  Fluid Mechanics and Hydrology  |  Turbomachines  |  HM 365  |  HM 365.19
HM 365.19 Vane Pump Module Show data sheet (pdf file)
Technical Description
Impeller pumps are used, when high delivery pressure is a must. The pump is fitted to a base plate ready for installation. The plate is simply slid into the HM 365.10 Basic Module Water Pumps and fixed in place. The unit is equipped with electronic sensors for recording intake and delivery pressure. After filling with water, the pump is connected to the experimental set-up using flexible hoses. To be able to interchange the pump easily and straightforwardly, the hoses are equipped with rapid action couplings. The motor necessary for drive is fitted to the HM 365 Universal Drive and Brake Unit.
Learning Objectives / Experiments
Together with the HM 365 Universal Drive and Brake Unit and the HM 365.10 Basic Module Water Pumps, the following experiments are possible:
· Recording of pump curves
· Determination of the power requirement of the pump
· Determination of the hydraulic power output of the pump
· Determination of the pump efficiency
· Determination of the system characteristic and operating point of the pump
Features
Investigation of the pump characteristic of an impeller pump
Available accessories
HM 365 -- Universal Drive and Brake Unit
HM 365.10 -- Water Pump Supply Module
Specification
[1] Impeller pump for operation on the HM 365.10 Basic Module Water Pumps
[2] Pump complete with connections and sensors fitted to base plate
[3] Max. capacity 7.2m³/h
[4] Max. head 70m water column
[5] Nominal speed 1500rpm
Technical Data
Maximum capacity: 7.2m³/h
Maximum head: 70m WC
Nominal speed: 1500rpm
Intake connection diameter 1”
Delivery connection diameter 1”
Dimensions and Weight
l x w x h: 500 x 300 x 400 mm
Weight : approx. 18 kg
Scope of Delivery
1 impeller pump, fitted to base plate complete with connections and sensors
Order Details
070.36519 HM 365.19 Vane Pump Module
© 2005 G.U.N.T. Gerätebau GmbH