Products  |  Thermodynamics, Heating and Sanitary Systems  |  Internal Combustion Engines  |  CT 400  |  CT 400.02
CT 400.02 4-Cylinder Diesel Engine Show data sheet (pdf file)
Technical Description
In conjunction with the CT 400 brake unit, the CT 400.02 test engine makes up a complete engine test stand. The engine is a 4-cylinder in-line engine. It has an integral closed cooling water circuit.
A solid, welded base frame on rollers carries the entire setup. Hazardous areas such as hot surfaces and rotating parts are covered with perforated plates. The engine is connected to the CT 400 brake unit using an elastic coupling with a jointed shaft. The test engine is attached to the brake unit using toggle-type fasteners.
 
The engine is fitted with sensors that measure the temperatures and the cooling water flow rate. The control cabinet contains all of the electronic equipment for managing the engine (factory set). On the control cabinet are an ignition key, an operating time counter and warning lamps. Data is transmitted between the CT 400 brake unit and the engine via a data cable connecting the control cabinets for the two units.
 
For safety reasons, the engine has been adjusted so that it is only possible to start it when it is connected to the brake unit both mechanically and electrically.
 
Learning Objectives / Experiments
In conjunction with CT 400 brake unit
- Plotting of torque and power curves
- Determination of specific fuel consumption
- Determination of volumetric efficiency
- Determination of excess air factor
- Creation of energy balances
  + overall engine efficiency
Features

* Test engine for setting up an engine test stand in

  conjunction with the CT 400 brake and control unit1
* Closed cooling water circuit1
* Easy “docking” with CT 400 brake unit
Alternative products
CT 400.01 -- 4-Cylinder Petrol Engine
Specification

[1] Water-cooled 4-cylinder diesel engine for setting up an engine test stand in conjunction with CT 400 brake unit
[2] Engine mounted on mobile, vibration-proof frame
[3] Power transmission to brake unit via elastic coupling and a jointed shaft
[4] Engine complete with fuel supply (tank, pump, line) and cooling water circuit
[5] Sensors for cooling water flow rate and temperatures (exhaust gas, cooling water, fuel, oil)
[6] Transmission of measured data via data cable from control cabinet to CT 400 control cabinet
[7] Control cabinet with warning lamps (oil pressure, alternator failure, preglow), operating time counter and ignition key

 
Technical Data

Water-cooled 4-cylinder diesel engine
- displacement: 1968cm³
- bore: 81mm
- stroke: 95.5mm
- power output: max. 47kW at 3000rpm
- torque: max. 200Nm at 1750rpm
 
Fuel tank capacity: 5L
Engine oil: SAE 5W-30

 
Dimensions and Weight
l x w x h : 1250 x 1150 x 1400 mm
Weight : approx. 250 kg
Connections
230V, 50/60Hz, 1 phase or 230V, 60Hz, 3 phase
Scope of Delivery
1 engine, installed in frame
1 instruction manual
Order Details
063.40002  CT 400.02  4-Cylinder Diesel Engine
© 2005 G.U.N.T. Gerätebau GmbH