Home           Products           Company           Contact us     
Theory of Machines and Properties of Materials
Mechatronics
Thermodynamics, Heating and Sanitary Systems
Fluid Mechanics and Hydrology
> Fundamentals of Fluid Mechanics
> Flow in Pipes
> Turbomachine Demonstrators
> Turbomachines
> Fundamentals of Aerodynamics and Airflow
> Hydrology and Hydraulic Engineering
> Components in Piping Systems
Process Control and Process Engineering
Overviews
Products  |  Fluid Mechanics and Hydrology  |  Turbomachine Demonstrators  |  HM 287
HM 287 Axial-Flow Reaction Turbine Demonstrator Show data sheet (pdf file) Print page
Technical Description
The HM 287 axial turbine represents a model of a reaction stage as found in gas and steam turbines. The model can be completely independently operated, as it is provided complete with a supply tank, pipework, pump and instrumentation on a laboratory trolley. The flow rate in the sealed water circuit is determined using a differential pressure measurement at a measuring orifice and can be adjusted using a ball-cock. The moment present on the turbine shaft is measured using a dynamometric brake with an electronic force sensor. In addition, the turbine speed is measured using an inductive proximity switch. The following accessories are required for operation: an Interface Module (HM 280.01), Data Acquisition Card with Software (HM 280.03) and Set of Connecting Cables (HM 280.04). Using these accessories it is possible to take measurements, and process and store the measurements on a PC.
Learning Objectives / Experiments
· Determination of the power output
· Determination of the efficiency
· Preparation of the characteristic curve
· Comparison of experiment and calculation
Features
Fully functional demonstration model of an axial turbine
Transparent turbine housing
Electronic data acquisition
Processing of measured data on a PC
Available accessories
HM 280.01 -- Interface Module
HM 280.03 -- Data Acquisition Card with Software
HM 280.04 -- Set of Connecting Cables
Alternative products
HM 270 -- Air-Operated Impulse Turbine
HM 288 -- Radial-Flow Reaction Turbine Demonstrator
HM 289 -- Pelton Turbine Demonstrator
HM 291 -- Axial- Flow Impulse Turbine Demonstrator
HM 405 -- Axial-Flow Turbomachines
Specification
[1] Axial turbine demonstration unit
[2] Turbine complete with supply equipment and instrumentation
[3] Experimental set-up on laboratory trolley
[4] Turbine with transparent housing, approx. 250W, rotor diameter 50mm
[5] Electronic measurement of flow rate, pressure drop over the turbine, rotational speed and load on the turbine shaft
[6] Processing of measured data on a PC
[7] Determination of flow rate using differential pressure measurement across a measuring orifice
[8] Pipework and supply tank made of corrosions-resistant materials
Technical Data
Turbine
Rating: approx. 250W at 4000rpm
Rotor diameter: 50mm

Pump 0.75kW
Max. pump capacity: approx. 300Ltr/min
Max. head: 19m

Measuring range for volumetric flow measurement 500Ltr/min
Measuring range for pressure measurement 0..2bar
Measuring range for moment 0..2Nm
Measuring range for speed measurement 0..10000rpm
Dimensions and Weight
L x w x h: 1000 x 600 x 1100 mm
Weight : approx. 100 kg
Connections
230V,~50Hz
Scope of Delivery
1 turbine, complete with supply and instrumentation,
1 instruction manual
Order Details
070.28700 HM 287 Axial-Flow Reaction Turbine Demonstrator
Print
© 2005 G.U.N.T. Gerätebau GmbH