|
|
| This large test device is used for bending, loading and compression experiments on girders, bars, trusses and other components from the area of steel construction and civil engineering. It is specially designed to make it possible to perform experiments on large design elements in 1:1 scale. The device consists of two support frames and two load frames that are anchored to the floor of the laboratory using threaded studs. Due the open at the front and rear design, it is possible to test specimens of almost any length. The frame design withstands a central load of up to 400kN. The test forces in the load frames are generated using two hydraulic cylinders. The necessary hydraulic pressure is provided by a hand operated hydraulic unit. This has two pump stages, in case of a requirement for high force, the unit automatically switches between the two stages. The possible uses for the device are almost unlimited. The design of the frame facilitates the rapid, uncomplicated set up of numerous experiments. Test objects are not included. Data acquisition software is available as an accessory. |
 |
Learning Objectives / Experiments |
| · Bending, loading and compression experiments on large girders, bars, trusses and other components from the area of steel construction and civil engineering |
|
|
|
Features
|
|
|
Loading device for bending and compression experiments on design elements from civil engineering and steel construction
Specially designed for large components (scale 1:1)
Load capacity up to max. 400kN
Hand operated hydraulic system |
|
|
|
Alternative products
|
|
|
SE 080 -- Test Frame for Pillars
SE 100 -- Universal Testing Frame, 400 kN
|
|
|
| Specification |
[1] Large loading device for bending and compression testing of bars, girders, trusses or similar design elements from steel construction and civil engineering
[2] Consists of two load frames with hydraulic cylinders and two support frames
[2] Sturdy design made of steel section
[3] Attachment using floor anchors
[4] Free frame width 1085mm
[5] Test object height 0...2100mm
[6] Adj. steps of the cross-members 200mm
[7] Hydraulic cylinder, stroke 300mm, compression force max. 286kN, tensile force max. 139kN
[8] Max. load capacity 400kN, central
[9] Two stage hand pump with automatic changeover, oil capacity: 7.5ltr |
| Technical Data |
Free frame width: 1085mm
Test object height: 0...2100mm
Permitted test forces:
Central position 400kN, off-centre 2 x 280kN
Support height: min. 870mm, max. 3470mm
Compression piece height: min. 440mm, max. 3040mm
Adjustment steps: 200mm
Hydraulic cylinder, stroke: 300 mm
Compression force: max. 286kN,
Tensile force: max. 139kN
Two stage hydraulic hand pump with automatic changeover, oil capacity 7.5ltr |
| Dimensions and Weight |
Each frame l x w x h : 1300 x 510 x 3700 mm
Weight of each frame : approx. 625 kg |
| Scope of Delivery |
2 support frames,
2 load frames,
1 hydraulic unit,
1 instruction manual
Supplied without measurement specimens |
| Order Details |
022.09000 SE 090 Static Structural Testing System
|
|
