G.U.N.T. - Equipment for engineering education -

Home

Products

Company

Theory of Machines and Properties of Materials

>	Statics
>	Dynamics
>	Mechanical Demonstration Models
>	Applied Physics
>	Strength of Materials
>	Stress and Strain Analysis
>	Theory of Machines
>	Material Testing
>	Structural Mechanics

Mechatronics

Thermodynamics, Heating and Sanitary Systems

Fluid Mechanics and Hydrology

Process Control and Process Engineering

Overviews

Products | Theory of Machines and Properties of Materials | Structural Mechanics | SE 110 | SE 110.11

SE 110.11

Experimental Set Bending Moment (Influence Lines)

Technical Description

The set is used with the SE 110/SE 111 universal test frames to demonstrate the bending moment in beams loaded with point forces. Due to the use of a low-friction joint at 1/3 of the span of the beam and a dynamometer combined with a lever, the bending moment in the beam can be measured directly. The deflection of the beam as a result of the measurement travel of the gauge can be compensated with adjustment bolts. The beam is loaded using sets of weight that can be attached to the beam at any point. The bearing supports are fitted to the universal frames using special clamps. The supports are equipped with low-friction ball bearing mounted rollers.

Learning Objectives / Experiments

· Demonstration of the section principle in mechanics
· Calculation of section load on the bar
· Bending moment along the bar

Features

· Special low-friction joint in the beam
· Beam deflection compensation by adjustment of measurement travel

Alternative products

SE 110.15 -- Experimental Set Bending Moment and Shear Force
WP 960 -- Shearing Force and Bending Moment Apparatus
WP 962 -- Bending Moment Apparatus

Specification

[1] Supplementary experiment for the table-top system SE 110/SE 111, bending moment in a beam (influence lines)
[2] Total length 1000mm, span 800mm
[3] Special low-friction joint at 266mm, rigid to normal and shear forces
[4] Measuring range for moment 0...14Nm
[5] Max. load 20N
[6] Ball bearing mounted bearings, width 20mm

Technical Data

Total length: 1000mm
Span: 800mm
Max. load: 20N
Measuring range for moment: 0...14Nm

Dimensions and Weight

Weight : approx. 11 kg

Scope of Delivery

1 experimental set, complete,
1 instruction manual

Order Details

022.11011 SE 110.11 Experimental Set Bending Moment (Influence Lines)