Home           Products           Company           Contact us     
Theory of Machines and Properties of Materials
> Statics
> Dynamics
> Mechanical Demonstration Models
> Applied Physics
> Strength of Materials
> Stress and Strain Analysis
> Theory of Machines
> Material Testing
> Structural Mechanics
Mechatronics
Thermodynamics, Heating and Sanitary Systems
Fluid Mechanics and Hydrology
Process Control and Process Engineering
Overviews
Products  |  Theory of Machines and Properties of Materials  |  Structural Mechanics  |  SE 110  |  SE 110.12
SE 110.12 Experimental Set Influence Line Show data sheet (pdf file) Print page
Technical Description
This experimental set is for use with SE110 Universal Structural Testing Frame or the SE 111 Universal Test Frame. With the aid of this set, the influence lines on the bearings on a three part beam under a moving load can be investigated. In addition, the reaction forces can be calculated under static load. Loading is performed using weights as a point or distributed load, or using a carriage as a moving load. The changes under load can be clearly seen. The reaction forces are indicated directly on dynamometers in the bearing supports. The experimental set contains all the necessary individual parts, these are attached to the respective frame using rapid action clamps.
Learning Objectives / Experiments
· Reaction forces and influence lines on a three part bridge girder with variable bearing points under
- Point load
- Distributed load
- Moving load
Features
Experimental investigation of a three part beam in various load cases
Alternative products
EM 043 -- Reaction of Beams Apparatus
EM 044 -- Forces on a Beam Apparatus
SE 110.17 -- Experimental Set Three Hinged Arch
SE 110.54 -- Experimental Set Equilibrium of a Beam
Specification
[1] Supplementary experiment for the SE 110/SE 111 table system, influence lines on a three part beam under varying load
[2] Total beam length 1220mm, two joints
[3] 4 dynamometers ±50N
[4] 2 position meas. gauges 0..25mm, res. 0.01mm
[5] Bearing points can be slid as required
[6] Fixing with rapid action clamps
Technical Data
Beam length: 1220mm
Load weights: 25N and 50N
Dynamometer: ±0...50N
Deformation dial gauge: 0...25mm, resolution 0.01mm
Dimensions and Weight
l x w x h : 1220 x 120 x 550 mm
Weight : approx. 25 kg
Scope of Delivery
3 beam sections, 4 dynamometers, 2 position gauges, 2 load weights, 1 instruction manual
Order Details
022.11012 SE 100.12 Experimental Set Influence Line
Print
© 2005 G.U.N.T. Gerätebau GmbH