Home           Products           Company           Contact us     
Theory of Machines and Properties of Materials
> Statics
> Dynamics
> Mechanical Demonstration Models
> Applied Physics
> Strength of Materials
> Stress and Strain Analysis
> Theory of Machines
> Material Testing
> Structural Mechanics
Mechatronics
Thermodynamics, Heating and Sanitary Systems
Fluid Mechanics and Hydrology
Process Control and Process Engineering
Overviews
Products  |  Theory of Machines and Properties of Materials  |  Strength of Materials  |  FL 160
FL 160 Unsymmetrical Cantilever Apparatus Show data sheet (pdf file) Print page
Technical Description
On this table unit, the arrangement of the beam specimens on their side enables the experimental set-up to be clearly seen. By observing the beam from the front, the bending of the beam can be easily observed. The interchangeable beams of U, L and I section are clamped at one end in a solid support and the angular position indicated on a graduated disc. A point load is applied to the free end using a set of weights. The locating bolts facilitate a 25mm offset of the application of force for generating a combined torsion/bending load. This is necessary for investigating the shear centre. Dial gauges measure the deflection of the end of the beam. Precise zeroing is possible using adjustment bolts.
Learning Objectives / Experiments
· Straight bending of a beam of I cross-section
· Unsymmetrical bending of a beam of L cross-section
· Torsion moment and shear centre on a beam of U cross-section
Features
· General and unsymmetrical bending of straight beams
· Shear centre
Alternative products
SE 110.23 -- Experimental Set Shear Centre
SE 110.27 -- Experimental Set Unsymmetrical Bending
Specification
[1] Table-top experiment for general and unsymmetrical bending of straight beams
[2] Three beams of I, L and U cross-section
[3] Deformed beam length 500mm
[4] Distance to the load application point 540mm
[5] Load application offset 0...25mm
[6] Dial gauges: 0...10mm, resolution 0.01mm
[7] l x w x h 700x350x400mm
Technical Data
Deformed beam length: 500mm
Load application point offset: 0...25mm
Dial gauges: 0...10mm, resolution 0.01mm
Weights set: 5...60N
Dimensions and Weight
l x w x h : 700 x 350 x 400 mm
Weight : approx. 25 kg
Scope of Delivery
1 table unit, 3 bending beams, 2 dial gauges, 1 set of weights, 1 instruction manual
Order Details
021.16000 FL 160 Unsymmetrical Cantilever Apparatus
Print
© 2005 G.U.N.T. Gerätebau GmbH