Home           Products           Company           Contact us     
Theory of Machines and Properties of Materials
> Statics
> Dynamics
> Mechanical Demonstration Models
> Applied Physics
> Strength of Materials
> Stress and Strain Analysis
> Theory of Machines
> Material Testing
> Structural Mechanics
Mechatronics
Thermodynamics, Heating and Sanitary Systems
Fluid Mechanics and Hydrology
Process Control and Process Engineering
Overviews
Products  |  Theory of Machines and Properties of Materials  |  Structural Mechanics  |  SE 110  |  SE 110.48
SE 110.48 Experimental Set Plastic Bending Show data sheet (pdf file) Print page
Technical Description
This experimental set is a supplementary experiment for the SE 110 or SE 111 universal testing frame. The set is used to demonstrate the behaviour of a bending beam in the plastic deformation region. The set contains a test bar made of steel that is clamped at both ends and loaded in the middle. A dial gauge is used to measure deformation. In this way the transition from the elastic to plastic deformation region can be exactly observed and determined. From the data thus obtained, a stress-strain diagram is plotted, this demonstrates the influence on the plot of the geometry. The SE 110.34 Loading Device is required to perform the experiment, this is not included.
Learning Objectives / Experiments
· Loading of a bending bar using a single force
· Comparison of the load application and load removal curve
Features
Exact observation and determination of the transition from elastic to plastic deformation
Available accessories
SE 110.34 -- Loading Device with Force Gauge, 5000 N
Alternative products
SE 110.55 -- Experimental Set Plastic Bending of Portals
Specification
[1] Supplementary set for the SE 110 table system, plastic deformation of bending bars
[2] Loading a steel bar using a point force, comparison of load applic. and load removal curves
[3] Bar length 1000mm, cross-section 20x4mm
[4] Pos. meas. device 0..50mm,graduations 0.1mm
[5] Fixed and movable support for attaching the bar
[6] Assembly with rapid action clamps
Technical Data
Steel beam
Length: 1000mm
Cross-section: 20x4mm
Position measurement range: 0...50mm
Graduations: 0.1mm
Dimensions and Weight
Weight : approx. 13 kg
Scope of Delivery
1 experimental set, complete, 1 instruction manual
Order Details
022.11048 SE 110.48 Experimental Set Plastic Bending
Print
© 2005 G.U.N.T. Gerätebau GmbH